notes:
1) EVALUATE: 4(XY)/Y+3X+5, X=1, Y=-2

2) WHAT TYPE OF BEARING CANNOT BE GREASED?

3) WHAT IS THE RAISED PART OF A SHAFT CALLED?

4) HOW WOULD YOU SEAT A BEARING, BY USING THE OUTER SURFACE OR ENTER SURFACE?

5) WHAT IS THE PURPOSE OF AN INDUCTOR?

6) WHAT TYPE OF COUPLING IS USED IN POWER SUPPLY TRANSFORMERS?

8) HOW WOULD YOU REMOVE A STRIPPED OUT ALLEN HEAD BOLT?

9) WHY ARE KEY WAYS PLACE ON A SHAFT?

10) HOW WOULD A BROKEN BOLT BE REMOVED?

11) WHAT KIND OF SOLDER IS NOT USED ON ELECTRONIC CIRCUITRY?

12) WHAT IS THE TRUTH TABLE FOR AN AND GATE & XOR GATE?

13) WHAT ARE THE ESSENTIALS ABOUT OIL?

14) WHAT IS THE DIFFERENCE BETWEEN OIL AND GREASE?

15) WHERE WOULD 10W AND 90W OIL BE USED?

16) THE NUMBER 6-32 MEANS WHAT TO A SCREW OR A BOLT?

17) WHY WOULD A STETHOSCOPE BE USED ON A CONVEYOR SYSTEM?

18) WHAT ARE THE FREQUENCY AND VOLTAGE OF THE SIGNAL IN FIG.TS1?

19) CAN YOU FOLLOW DIRECTIONS?

20) WHAT IS THE NEXT 3 NUMBERS IN THE SEQUENCE: 3,7,4,7,5,9,6,9,7...?

21) WHAT TOOL IS BEST SUITED FOR REMOVAL OF IMPREGNATED DEBRIS FROM A GRINDING STONE?

22) WHAT MEANS ARE USED TO REMOVE SLACK FROM A CONVOY BELT?

23) WHAT TOOL IS COMMONLY USE TO PUNCH HOLES IN SHEET METAL?